What Er:24 Means
Er:24 on a Bosch front-load washer means the relay that feeds power to the motor drive has failed. The Nexxt table calls it a motor power relay failure attributed to the control module; the Vision manual describes a power supply relay to the inverter that is stuck and gives one remedy, replace the control. Either way the problem is on the board rather than in the motor.
Common Causes of Er:24
- Motor power relay welded closed on the control module
- Relay failed open so the drive never gets supply
- Control module damage around the relay circuit
🔧 One Safe Check You Can Try
Isolate the machine at the breaker rather than only at the controls, because a stuck relay means a circuit that stays connected regardless of what the front panel is doing.
⚠ Why You Shouldn't Go Further Than That
- A relay stuck closed keeps the motor drive energised whatever the controls say, which is why the breaker is the right response.
- The relay is soldered to the control module, so this is a board replacement rather than a part swap.
- Bosch's own diagnosis uses the motor test program, which drives the drum and is not a mode to enter casually.
- Control boards are model specific, and a fitted board is generally not returnable if the diagnosis turns out wrong.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.
Technical Reference
- Code
- Er:24
- Appliance
- BOSCH washer
- Maker documentation
- BOSCH owner manuals and use & care guides
- Checked
- September 2026
Code meanings can change between control generations. Before acting on a code, match the full model number on your appliance's rating label against the manual for that model. We are an independent repair service, not affiliated with BSH Home Appliances Corporation.